2) I'm going to assume that you want to zoom into the photo and then have it display at the 100% setting for a short time period before transitioning to the next slide, correct? You'll need to do this with a couple of slides. In the first slide you set your starting zoom and then your ending zoom. The zoom effect will take as long as your slide duration, so if you set the duration for 5 seconds the zoom will take 5 seconds. What is currently happening is that your transition to the next slide is overlapping the slide by a small time frame so that is why the zoom never fully reaches the end position before the transition. To have the zoom finish and pause for a short period of time you'll need to add a second slide with the same image set to your ending zoom position. Between these two slides you'll want a "cut" transition set to 0. You'll then need to set your second slide duration to however you want it to display. By doing this you'll see your image zoom out from 800% to 100% and then hold before going on to the next image.
Hope that makes sense.
1) Slide A start & end with slide zoomed to 800% followed by 'Cut' transition of zero duration. Set duration of
Slide A to the time you wish it displayed BEFORE it starts to zoom out - try 2 seconds.
2) Slide B start with zoom of 800% reducing to 100% followed by 'Cut' transition of zero duration. Set duration
of Slide B to the time you wish the zoom out to take - try 8 seconds. Since you're zooming out over a large
range (800% - 100%), don't set this time too low or the zoom will seem rushed.
3) Slide C start & end with 100% zoom followed by your choice of transition to the next slide. Duration of
Slide C to be the time you wish the 100% zoomed image to remain on screen - try 2 seconds.
Hope this helps - Mike - UK
Now, a second question, but related. The zoom works fine, but I can't really start on the earring. It starts where it wants, which is close to the earring. Is there a way to focus on a part of the photo to start your zoom, or am I asking too much--maybe that's the stuff you get when you buy Producer.
Thanks for the quick feedback!
tjjl wrote:The zoom works fine, but I can't really start on the earring. It starts where it wants, which is close to the earring. Is there a way to focus on a part of the photo to start your zoom, or am I asking too much--maybe that's the stuff you get when you buy Producer.
You can move the position of the image's starting point to focus on the area you want displayed. You do the same as if you were to pan by changing the X & Y coordinates. Simply adjust the image so that your focus point is where you want it for your starting position. If you have a slide prior to the zoom as was suggested above make sure your X & Y coordinates match the starting point of your zoom.
Who is online
Users browsing this forum: No registered users and 0 guests