Drag & Drop in a Template
2 posts
• Page 1 of 1
- VernonRobinson
- ProShow Hall of Fame
- Posts: 1334
- Joined: Thu Dec 27, 2007 7:52 pm
- Location: Detroit, MI
Drag & Drop in a Template
I was looking at one of the templates available here. It looks like on several of the slides there may be 6 -20 pictures. I used "select file" to load the template. However, in another template it says to use "drag and drop" to load the layers. How does one go about doing this. This technique could make the templates a lot easier to use.
Thanks,
-Vernon
Thanks,
-Vernon
Try taking a look at the link below to the "sticky" thread for the template area of the forum.
If you don't see the answer there, post your question again in that sticky thread.
http://www.proshowenthusiasts.com/viewforum.php?f=16
Debbie
If you don't see the answer there, post your question again in that sticky thread.
http://www.proshowenthusiasts.com/viewforum.php?f=16
Debbie
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests